Hot Shot Shell Cutter


This is our original shotshell cutter, as you can see from the picture
it is drilled for 12ga and .410 shell dismanteling.  We also
manufacture a 20ga and 28ga shotshell cutter.

To use the cutter you just lift the lever (as shown in the picture).
Then insert the shell you wish to dismantle.

Press down on the lever as shown and rotate the shell until you hear or
feel a slight pop when the razor blade makes it through the shell.

Lift the lever and slowly remove the shell as a whole.  (It should
look like the one in the picture).

Lift the top of the shell off to reclaim the shot.

Now take out the wad.  Then reclaim the powder.  Now you have
a fully dismantled shotshell.

Buy the 12ga and .410 Cutter

Buy the 20ga and 28ga Cutter

Or buy Both Cutters for